3.5 inch digital LCD : Resolution: 320(RGB)*240
Underwater Camera : Definition: HD 600 lines, Viewing angle: 150 degrees wide angle
Gymbal : 3 Mini gymbals always seem shaped no matter how much you try to adjust
Cables : 1.5mm thick and its tension up to 15kg
1.Assembly method of floating ball:
Fixing the fishing line on both sides of the floating ball may make it more solid.
Firstly, on the red side of the ball, you can see a cylinder stand out. Just depress it and thread the fishing line, then release the cylinder.
Next, you need to depress the cylinder and iron hook on the red side. Then you will see an iron hook protrude from the green side, release it after threading the fishing line.
Finished product has clearly been shown in the picture on the right:
2.Assembly method of fishhook and center ring:
In general case, three fishhooks are enough when assembling the gang hook. Please note that the gap length should not be too long, 5cm is fine. So you can have a clear vision of all the fishing bait even on the line. If possible, you can extend the plumb line properly. As shown above.
The assembling of paralleling hook is flexible, you only need to adjust the distance between fishing hook and camera, then fix one hook with the center ring. As shown in the picture on the right.
You should bind the fish hook wire into camera's groove rightly! Never bind
It on the cable, or it will cause permanent fault. Right way has been shown
in the picture on the left:
3.Directions of wrench
Wrench aims to fasten the bracket behind the display. You can fasten the bracket if it is too loose!
4.Assembly method of buckle
You need a section of fishing line connected to the display along fishing rod when fishing. In order to prevent loosening and knotting of the fishing line,it is necessary to use the buckle to fasten the line.Right way has been shown above:
5.Binding of fishing line
Rubber sleave is used to protect the fishing line from knotting which may damage the line. First,you should adjust the rubber sleave to the place where needs knotting when binding. Then operate according to the following picture:
1.Move the rubber sleave to the place where needs knotting.
2.Knot the fishing line again. It's important to note that the kontting must be tied on the rubber sleave.
3.Knot fishing line and the rope of fishing rod in the end.
Finished product has clearly been shown above.
6.Effect picture after assembling.
|Horizontal resolution||HD 600 lines|
|Battery capacity||Built-in battery|
|Viewing angle||160 degrees wide angle|
|Battery type lithium battery|
|LED light||8 IR LED light|
|TV line||420TV line|
|Display screen||3.5 inch CLCD|